Free engineerin' tool

Steel Weight Calculator

Figure out what y'all's steel plate, flat bar, round bar, square bar, hex bar, pipe or tube weighs. Pick your shape and material, punch in the size in inches or millimeters and the length, and the calculator gives you the weight of one piece and the whole lot in pounds and kilograms, plus the weight per foot or per square foot. For rings and discs, use the ring weight calculator; for pipe by NPS and schedule, use the pipe schedule & weight calculator.

in
in

Plate / flat bar · Carbon / alloy steel

40.84 lb

18.52 kg total for 1 pc

Weight per piece
40.84 lb (18.52 kg)
Weight per area
40.84 lb/ft² (199.39 kg/m²)
Cross-section area
12.000 in² (7,742 mm²)
Quantity
1

Theoretical weight off nominal dimensions and typical density. Mill tolerances, corner radii and coatings change the real weight, so Texas Flange sales confirms y'all's shipping weight with your quote.

This here's a reference tool for plannin' and quotin'. Check it against your purchase spec and your site's procedures before y'all go usin' it.

Get y'all a flange quote

Questions Folks Ask Us

How y'all figure the weight of steel?

Multiply the cross-section area by the length to get your volume, then multiply that by the density. Carbon steel runs about 0.2836 lb per cubic inch (7.85 g/cm³), so a 1 inch thick plate 12 by 12 inches comes in around 40.84 lb.

How much does a 1 inch steel round bar weigh a foot?

Right around 2.67 lb a foot in carbon steel. A 1 inch square bar runs about 3.40 lb a foot and a 1 inch hex bar (across flats) about 2.95 lb a foot.

Is stainless heavier than carbon steel?

Just a hair. 304 and 316 stainless run about 2% heavier than carbon steel for the same size, duplex 2205 is about the same as carbon steel, and aluminum is roughly a third of the weight.

How do I find what steel pipe weighs?

Pick Pipe / tube and punch in the outside diameter and wall thickness. A 6 inch standard wall pipe (6.625 inch OD, 0.280 inch wall) comes out around 18.99 lb a foot. To pick a size by NPS and schedule, use the pipe schedule & weight calculator.

Are these weights exact?

No, cher. They're theoretical weights off nominal dimensions and typical densities. Mill tolerances, corner radii, coatings and the exact alloy all change the real weight, so Texas Flange sales confirms y'all's shipping weight with your quote.

The Parts Y'all Need, When Y'all Need 'Em

Texas Flange been deliverin' precision flange solutions with speed, good prices, and real know-how since 1986. Let's sit down and talk about your project today, y’all!

flange-basis